Blue Coat SG510 Series, Installation Manual

Page: 22 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 22
System LCD and Modes
The system has three modes.
Status Mode The default mode. Before the system is configured, the LCD
in Status mode displays
IP address not configured
. After
initial configuration, the LCD in Status mode displays CPU
utilization and freshness statistics.
In Status mode, there is no cursor in the LCD.
Configuration
Mode From Status mode, push the
Enter
button to go to
Configuration mode. In Configuration mode, you can use
the
Up
and
Down
arrow buttons to cycle the LCD through
the six networking parameters (IP Address, Subnet mask,
Gateway address, DNS address, Console Password, and
Enable Password).
In Configuration mode, the cursor is an underscore in the
LCD.