Chapter 2: First-Time Configuration
17
information for future reference. Close the new browser window and the Initial Configuration
page.
Figure 2-7: Successful Initial Configuration Page
10
Relocate the SG200 to its final destination in the network:
a.
Power off the SG200.
b.
Remove the Ethernet cable from the SG200 and restore it to your PC.
c.
Place the SG200 into the network (see
Section B: “Placing the SG200 into the Network
When you have set the basic networking parameters and connected the SG200 to the network, you are
ready to fully configure the appliance. For a list of all CLI commands, refer to the
Blue Coat ProxySG
Command Line Reference
. For information about configuring and administering the SG200 (including
information about setting policies that will explicitly grant or deny proxied transactions), refer to the
Blue
Coat ProxySG Configuration and Management Guide Suite
.
