10
Blue Coat SG200 Series
Powering on the SG200
Power on the SG200 by plugging in the power supply adapter and power cable.
1
Plug the power supply adapter into the SG200, ensuring that the barrel of the power supply adapter is
fully inserted into the SG200.
2
Plug one end of the power cable into the power supply adapter.
Figure 1-7: Plug in the Power Adapter and Power Cable
3
Plug the other end of the power cable into a power outlet.
The SG200 powers on and the operating system boots up. While the SG200 is booting up
(approximately one minute), the Power LED on the front panel (the left-most LED) glows solid amber.
4
After the SG200 boots up, verify that the Power LED behaves as described below:
If the Power LED is solid green after booting up, an initial configuration has already been performed.
If you did not perform an initial configuration, restore the appliance to its factory defaults to restart
the initial configuration (see
“Resetting the SG200 to Its Factory Defaults”
Important:
The use of a wall-socket adapter is not recommended. Country-specific power
cables are required to maintain product safety compliance and the warranty.
Configuration Status
Power LED Activity
Not completed
Flashing green and amber
Completed
Solid green
Plug the power supply
adapter into the SG200
Plug the power
cable into the power
supply adapter
Power LED
