Blue Bird M380 2003, Owner'S Manual

Page: 83 / 579

M380 Owner’s Manual________________________________Instruments and Controls - Driver and Co-Pilots Area – 2-2
Rev. “F” 2-2-11
If the units of measure are “US” or “Metric” and you fail to enter the
password correctly after five attempts, you will be locked out for 10
minutes. If the units of measure are “UK” or “Europe” and you fail to
enter the password correctly after three attempts, you will be locked
out for 30 minutes. When this lockout occurs, this screen will be
displayed.
NOTE: The ignition key must be ON to allow the lockout timers to operate for the required 10
or 30 minutes.
2-2.9.5.7 Changing the Password
Press
. Select “Change Password.” If the RoadRelay 4 is in “Fleet
Mode,” you will not be able to change this setting. (Fleet mode can
only be turned ON or OFF using INFORM™/INSPEC™ office
software.) The following screen will be displayed:
Once the existing password has been correctly entered, this screen is
displayed and a new password can be entered.
You MUST confirm the new password on the following display. If this
fails, the password is NOT changed.
Do not forget your password! When protected by the antitheft
feature, the engine will not start without entering the password. Do not write your password where a
thief can find it. Keep it someplace safe where you can find it easily.
Refer to the
Warranty section for important antitheft warranty information.
2-2.9.5.8 Idle Lock
If the engine is a Cummins ISB, ISC, ISL, ISM, ISX, or Signature 600, it may be locked while idling. If
locked while idling, it will ignore accelerator pedal changes until unlocked.
NOTE: This feature is not available if the units of measure are “UK” or “Europe.”
To lock or unlock the engine, press
and select “Lock/Unlock Engine.” Refer to the How to Lock
the Engine section. The unlocking procedure can be seen in the How to Unlock the Engine section.
2-2.9.6 Driver ID
Related sections: Using the Keypad .
RoadRelay 4 can record separate information for up to four drivers using the Driver ID function. You
can select up to three drivers. In addition, you can select the “Other” driver.