Blue Bird M380 2003, Owner'S Manual

Page: 52 / 579

1-1 - Safety and Security - Security Features____________________________________________M380 Owner’s Manual
1-2-20 Rev. “F”
or pressing the transmitter’s small lower button turns the feature off. Features which are not “on or off”
features, such as the alarm duration of 30 to 60 seconds, are noted otherwise.
To Enter Programming Mode:
1. Turn the vehicle’s ignition on.
2. Turn the ignition off.
3. Within 5 seconds, press and release the Valet Switch 5 times.
- The siren will chirp then sound briefly and the Status Light will flash to confirm that the
system is entering Programming Mode.
- Once in Programming Mode, if 10 seconds of no programming activity occurs, the system will
exit Programming Mode. Programming activity is the pressing of the Valet Switch or pressing
a transmitter button once a feature is accessed.
To Access a Feature:
4. Within 10 seconds, press and release the Valet Switch the same number of times as the desired
feature’s number.
- The siren will chirp and the Status Light will flash as many times as the Valet Switch was
pressed to indicate the feature number which is now accessed.
To Change a Feature:
5. After accessing the desired feature, within 10 seconds, press and release either the transmitter’s
large upper button or the small lower button.
- Pressing the large upper button turns the feature on; the siren will chirp once and the Status
Light will turn on.
- Pressing the small lower button turns the feature off, the siren will chirp twice and the Status
Light will turn off.
To Access and Change further Features:
6. If there are more features to be programmed, within 10 seconds of the previous action press and
release the Valet Switch the same number of times as the next desired feature’s number.
- Again the siren will chirp and the Status Light will flash as many times as the Valet Switch
was pressed to indicate the new features numbers which is now accessed.
- Use the transmitter as described in Step 5 to change the newly accessed feature as desired.
-
Repeat this Step 6 for each additional feature until all features are programmed.
To Exit Programming Mode:
7. Allow 10 seconds to pass without performing any programming actions; or turn the vehicle’s
ignition on.
- The siren will sound briefly and the Status Light will go out to confirm that the system is
exiting Programming mode.
IMPORTANT NOTE: Once the system is in Programming Mode, if at any time 10 seconds
elapse without programming activity, the system will automatically exit Programming Mode.
To prevent the system from prematurely exiting Programming Mode, the feature can be
entered again by pressing the Valet Switch, or if a feature is accessed, by pressing either of
the buttons. Features can be selected in any order as desired.
The following pages explain each of the programmable features in detail, including how to program
transmitters and how to customize your system’s SecureCode. Following the features explanation is a
convenient feature programming checklist, which greatly simplifies the feature programming process.
1-2.4.18 The 745i³ Programmable Features
Feature #1 Transmitter Programming Mode
The first level in the programmable features menu is Transmitter Programming Mode, by which
additional or replacement transmitters can be programmed to operate the system. It is important to
note that when a transmitter is programmed into the system, the ATV Warning is activated and all
previous transmitter codes in the system’s memory are deleted.