M380 Owner’s Manual________________________________Instruments and Controls - Driver and Co-Pilots Area – 2-2
Rev. “F” 2-2-41
For warranty purposes, parts used in a warrantable repair assume the identity of the parts they
replace.
CUMMINS DOES NOT COVER WEAR OR WEAROUT OF COVERED PARTS.
CUMMINS IS NOT RESPONSBILE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES.
CUMMINS ENGINE COMPANY MAKES NO OTHER REPRESENTATION OR WARRANTY,
EXPRESS OR IMPLIED, INCLUDING NO WARRANTY OF MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE. UNDER NO CIRCUMSTANCES WILL CUMMINS ENGINE COMPANY
BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL, OR PUNITIVE DAMAGES, INCLUDING
WITHOUT LIMITATION LOST PROFITS OR INCOME, DAMAGE TO FREIGHT, AND LIVING OR
TRAVEL EXPENSES, IN THE EVENT OF THEFT, OR IF THE ANTITHEFT FEATURE PREVENTS
THE ENGINE FROM STARTING FOR ANY REASON, INCLUDING CUMMINS OWN NEGLIGENCE.
This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state.
In case of consumer sales, in some countries the Owner has statutory rights that cannot be affected
or limited by the terms of this warranty.
Nothing in this warranty excludes or restricts any contractual rights the Owner may have against third
parties.
*Locations in the United States and Canada are listed in the Cummins United States and Canada
Sales and Service Directory; other locations are listed in the Cummins International Sales and
Service Directory. You can also find service locations for the United States, Canada and
Internationally by going to:
http://www.cummins.com/service_locator/index.cfm
2-2.19 Printers and Printer Cables for RoadRelay 4
This section explains the cabling requirements for the small printers commonly used with heavy-duty
electronic tools: The WeightTronix and MPSI Seiko printers.
To connect the RoadRelay 4 to a printer, you will need a RoadRelay extraction harness (Cummins
Part Number 4003775) and a printer cable from the following table.
Change the dipswitch settings on the Seiko printer from the factory defaults to the following:
*Turning this switch off changes the printer from 2400 to 9600 bps, which is the required RoadRelay interface.
(These settings are the same as specified by Echek™ and Compulink™.)
Switch#
1
2
3
4
5
6
Default
on
on
on
of
on
off
Set to:
on
on
on
off
off*
off
Switch#
1
2
3
4
5
6
7
8
Default
off
on
on
on
off
on
on
on
Set to:
off
off
on
on
on
off
on
on
Summary of Contents for M380 2003
