Shako Rocket Tosen
B28-VSF-007
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Note
–
For this model you may find it easier to build sub-assemblies and paint them before attaching them to the model.
Two examples of these are the engine module and sails.
We also painted all the metalwork on the side and hull panels prior to assembly.
First construct two rocket bells from the pieces
shown above.
Start by glueing the internal supports together.
Place the largest ring over the supports, aligning
the flat portions of the inner ring with the
supports. Repeat for the other rings.
The sides of the rocket are formed from these
pieces.
Glue the semi-circles into the central space as
shown.
The axle is made from these pieces.
