28mm Submarine: Main Deck
B28-WW2-300
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the front and rear main supports plus the
central cross beam and two side supports from
the sprue as shown above.
Glue the cross beam to the front and rear supports.
Attach the side supports into the gaps provided.
Take the side pieces shown above from the sprue.
Starting from the bottom, glue each strip into
place.
Then attach the upper strip.
Repeat this on the other side of the model.
Glue the top plate into position.
