28mm Dark Age Watch Tower
B28-DA-008
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the floor and corner supports from the
sprue.
Glue the floor to the supports using the slots
provided. (with the planks upwards)
Take the four lower bridge supports.
Turn the model upside down and glue them to the
underside of the floor as shown above.
Turn the model upright again and attach the base.
The inner wall sections.
Glue these into place with the planks facing
inwards.
Take the outer frames.
