20mm Stables
B20-MD-019
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
You may find it easier to paint portions of this model
BEFORE
construction
–
please see the end of the document for info
about this.
Take the wall sections and base from the sprue.
Glue the walls to the base with all the etched detail
facing
inwards
.
Take the inner walls.
Add the inner wall with the lugs with the etched
detail facing to the right (see pic).
Then add their partner pieces.
Take the outer frames.
