Bridge Assembly
B20-DIDG-xxx
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Arched Bridges for use with EMB tiles
Single Span arched bridges
The length of these vary, but the technique to build them is the same. For longer bridges the central
section of roadway is supplied as a single piece rather than multiple smaller ones.
Remove the pieces for one side of the bridge
from the sprue.
Glue the pieces back-to-back to form a thicker section.
Glue the pieces of roadway into place
–
note the
end sections are left off at this stage.
Add the inner face of the other side of the bridge,
gently guiding the ends of the roadway into thir
appropriate slots.
Glue the outer face of the bridge into position.
Turn the bridge onto its back and add the end
sections.
