15mm Terrace - B15-WW2-100
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
When gluing pieces to the base sections (G and L),
ensure you do not get glue into the corner holes (see
picture) as these are used to hold the levels together.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
Ground Floor
Remove the following sections
from the sprue: Base (G)(x1),
long inner walls (I)(x2), short
inner walls (J)(x2).
Apply glue to lower edges and to
the back of the end lugs of all the
wall sections. Stick to the base so
the lugs on the bottom of the
walls sit within the spaces
provided on the base, with the
etched detail on the walls facing
outwards.
Remove
two
partition
wall
sections (N) from the sprue,
apply glue to both ends and the
bottom, then attach to the points
as shown.
Remove long outer walls (A)(x2)
from the sprue. Apply glue to
unpainted side and stick to long
inner walls.
Remove short outer walls (D)(x2)
from sprue and apply glue to
unpainted side. Stick to short
inner walls.
Put the lower floor to one side
and allow glue to dry.
Upper Floor
Remove the following sections
from the sprue: Base (G)(x1),
long inner walls (H) (x2), short
inner walls (J)(x2) and partition
walls (N)(x2).
Attach these together in the
same way as the ground floor.
Take long outer walls (B)(x2) and
short outer walls (C)(x2) and glue
to upper floor shell. Leave to dry.
