10mm Nuclear Power Station
B10-PS-004
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the three small walls and their roof from sprue as
shown above.
Glue the three walls together….
..;then glue the roof on top.
Take the back wall.
Glue the assembly to it as shown.
Take the other four walls and the base from the
sprue.
Glue those four walls plus the rear wall into place.
Glue the roof into position.
