10mm 5x1 Mixed Foyer
B10-MW-112
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Foyer (B10-MW-112)
Start by removing the sections shown above
(right) from the sprue. There are enough parts to
create all four doorway sections.
Glue them together as shown in the image on the
left.
Glue the doorways to the
back
of the long sides, using
the lugs/holes provided.
At the same time, glue a triangular bracer to the
back of the long sides at each end. Leave these to
dry.
Glue the two end walls into place then add the
decorative columns.
