6mm 3x3 Residential Foyer
B06-MW-101
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Foyer (B06-MW-101)
Remove the two “C” shaped sections and the
four shop fronts from the sprue.
Glue the shop fronts to the “C” sections as shown
(etched detail facing outwards) using the lugs on the
top edge of the shop fronts. The lugs on the ends of
the shop fronts will slot together. Leave to allow glue
to dry.
Now remove the four outer sections from the
sprue. Note, two of these pieces have 4 lug-holes
in them and two only have two-lug-holes in
them.
Once the inner section has dried, turn it over and glue
the outer sections onto it as shown, ensuring the outer
sections with the 4 lug-holes are glued to the 4 lugs on
the “C” sections.
Repeat for the other two outer sections.
Finally glue the decorative strips just above the
columns, so they cover the lug-holes. Note – two
strips are the same length as the walls and two
overlap slightly to give a continuous band.
