Blonder tongue Clearview 4:2, User Manual

Page: 9 / 24

9 Clearview 4:2
User Manual
(e) A dialog box entitled ”Internet Protocol Version 4 (TCP/IPv4) Properties” will appear. Select the “Use the following
IP address” option and enter the following addresses:
IP address: 172.16.70.2
Subnet mask: 255.255.255.0
No need to enter a value for the Default Gateway.
Click OK to close the dialog box. Your computer is now ready to communicate with the unit.
4.1 Ethernet Access (continued)
Open a web browser on your computer (Chrome or Firefox is recommended) and
enter the following URL address (http://172.16.70.1) . The “Login” screen ( Figure
4.2a) will appear.
Enter the following case-sensitive factory-default Username and Password and
click [LOG IN] .
NOTE: When logged in, the user has administrative read and write permissions.
Multiple users can log in simultaneously under the following credentials.
Username = Admin (case-sensitive)
Password = pass (case-sensitive)
4.2 Accessing the User Interface Via the Web Browser
You must complete the steps described in Section 4.1 before proceeding as follows:
Figure 4.2a - “Login” Screen
As shown in Figure 4.2b , under the “ Page Header ” the following Navigation tabs and links will appear:
• Navigation bar (left side): “ Status ”, “ System ”, “ Time ”, “ Transcoders: Status ”, and “ Transcoders: Settings ”
• Navigation bar (right side): “ Log ” and “ Firmware Update ”
• In addition, in the upper right corner above the navigation, the user can access the “ Admin ” screen through a link,
alongside the [ LOG OUT ] button.
Each Primary Navigation bar tab is described in the subsequent Sections.
Monitoring and configuration of the unit is achieved via a series of web pages as described in the Sections below. The following
read-only information is displayed in a “ Page Header ” at the top of each web page:
Name: displays a user-defined name to make identification easier. See Section 5.2, to configure this setting.
Location: displays a user-defined location to make identification easier. See Section 5.2, to configure this setting.
ESN: displays the unit’s serial number.
Uptime: displays the time elapsed since the last time the unit was turned on.
Version: displays the software version of the unit.
PAGE
HEADER
{
Figure 4.2b - Page Header and Navigation
1
2
6
7