29
AQT8 Series
User Manual
11.1 “Time” Tab
The “Time” tab (Figures 11.1a to 11.1d) allows the user to configure the time settings for the system and the event log.
Current Time at Page Load
System: read-only display of the unit's current date and time, shown in UTC format. The time is adjusted for states,
territories and countries that use time change (ie. Eastern Standard Time and Eastern Daylight Time).
Client: read-only display of the Client, or local browser, current date and time, shown in UTC format with time zone.
The time is adjusted for states, territories and countries that use time change (ie. Eastern Standard Time and Eastern
Daylight Time).
1
2
Figure 11.1a - “Current Time at Page Load”
1
2
Section 11 – General and System Configuration
Time Settings
Time Zone: user is able set the time zone, shown in UTC format.
Time: Clicking the button will synchronize the unit's time to Client time. This requires that the selected time zone and
client system time are correct. After synchronization, the unit's time shown may lead or lag the Client time by a small
margin.
3
4
Figure 11.1b - “Time Settings”
3
4
Figure 11.1c - “NTP Settings”
5
6
7
NTP Settings
Enable NTP System Time Synchronization: Enable ( ) or Disable ( ) System Time Synchronization.
5
