25
AQT8 Series
User Manual
Figure 8 - “IP Output” Tab - Full View
Figure 8.2 - IP Output Assignment
8.1 Add Output Streams Configuration
The parameters under “Add Output Streams Configuration” (Figure 8.1) are configurable for each stream output upon
adding. The user begins by assigning destination IP information as shown below:
Destination IP: User must enter the IP address or desired multicast IP address of the receiving equipment.
Destination Port:
User must enter the IP Port of the receiving equipment. The range is 1 to 65535.
Time-to-Live (TTL): A limit setting on the time that an IP packet can exist in an IP network. The value is set by the sender
of the packet, and is reduced by every host on the route to packet’s final destination. If the Time to Live reaches zero
before the packet arrives at its final destination, then the packet is discarded. The purpose of this field is to avoid an
undeliverable packet from circulating on an IP network perpetually. The range is 1 to 255.
8.2 IP Output Assignment
The “TS Available for IP Output Assignment” (Figure 8.2) column allows the user to select programs from the available TS
to add to IP Output. To select, check the box ( ) next to the programs to add to the IP Output. After configuration details
have been completed and the streams have been selected, the user can click to add the Input Stream to the IP Port.
The TS will then appear under the “TS Assigned as IP Output” column.
Figure 8.1 - “Add Output Streams Configuration”
1
2
3
1
2
3
Section 8 – IP Output
The “IP Output” tab (Figure 8) on the main navigation menu allows the user to select programs for IP output.
NOTE:
Clicking the small arrow ( collapsed; expanded) beside each program will show or hide further choices or read-
only data.
