Blizzard 57520-1, Owner'S Manual

Page: 33 / 40

Lit. No. 40688, Rev. 04 33 May 1, 2012
4. Remove the breather. Fill the reservoir to 1" from
the top and replace the breather.
5. Turn the control ON. Raise and lower the blade to
reposition the draw latch.
For fl uid recommendations, see the following Annual
Fluid Change section.
HYDRAULIC SYSTEM
Fluid Level
NOTE: Remove the breather slowly to relieve any
pressure in the reservoir.
1. With the snowplow attached to the vehicle and the
blade on the ground, turn the control OFF.
2. Move the Power switch to the center, or "OFF,"
position.
3. While holding the Power switch RIGHT, push
DOWN and hold the Arm/Blade Operation switch.
The arm will disengage the mount adapter and
fully retract the lift ram.
MAINTENANCE
CAUTION
Do not mix different kinds of hydraulic fl uid.
Some fl uids are not compatible and may cause
performance problems and product damage.
Breather
Reservoir
Drain Plug
Light
Tower
Power
Switch
Arm/Blade Operation
Switch
Switch
Label