Fermenator G4 V2
© Blichmann Engineering, LLC 2021
For replacement parts, visit: blichmannengineering.com/genuine-replacement-parts
5
If using the included airlock, install the 4” cap with gasket on
the lid with the 4” tri-clamp. Install the #8 stopper with air
lock as shown in
Figure 6
.
Figure 6
4” Tri-Clamp
4” Tri-Clamp Cap
4” Tri-Clamp Gasket
LID ASSEMBLY
Assemble the Brass Tee-Handle and the Bolt as shown. Place around the lid and flange and engage the latch over the bolt. Initially tighten
the clamp to about 1/2” (13mm) of gap between the band segments (
Figure 5
).
NOTE:
ALWAYS apply a dab of Vaseline or drop of oil on the threads of the draw bolt before each use to prevent wear and galling of the
threads. Galled or worn threads are NOT covered under warranty.
BEFORE USE, SPRAY ALL SURFACES WITH STARSAN AND ASSEMBLE
Less than 1/4”
(6.4mm)
Figure 5
If using the blowoff or spunding valves, see those man-
uals for assembly and operation.
