Page 1: ...e applied TOP SECTION r TOP AND MID SECTIONS MUST TOUCH AT THE PIVOT POINT BEFORE CLAMP SCREW IS FULLY TIGHTENED 3 Loosen the clamp screw so the top section separates from the mid section This will provide the necessary clearance to slide the mount over the mirror stem as shown above Adjust the mirror parallel to the windshield for ease of installation As you are tightening the clamp screw make su...
Page 2: ...ont of the RD upward with the other hand before sliding the RD off or onto the spring clip You must lift the front of the RD upward before sliding it off or onto the mount NOTE This mount can get extremely hot when sitting in direct sunlight If you intend to remove your RD frequently you may want to install the two gray TOUCH STRIPS included in the tool kit Place them where your fingers make conta...
