Blaze King TORINO II 1606, Operation & Installation Manual

Page: 40 / 49

OM-1606 E V1.03 April 2, 2014
Page 40
TORINO II Freestanding 1606
ALLOWABLE TERMINATION LOCATIONS
____________________________________________________________________________________________________
A= Clearance above grade, veranda
*(min. 12”/30 cm) *(min. 12”/30 cm)
porch, deck or balcony
____________________________________________________________________________________________________
B= Clearance to w indow or door
*(min. 12”/30 cm) *(min. 12”/30 cm)
that may be opened
____________________________________________________________________________________________________
C= Clearance to permanently closed
*(min. 12”/30 cm) *(min. 12”/30 cm)
w indow
____________________________________________________________________________________________________
D= Vertical clearance to ventilated
*min. 25-1/2” (65 cm) *min. 25-1/2” (65 cm)
soffit located above the terminal check w ith local check w ith local
from the centerline of the terminal code code
________________________________________________________________________________
E= Clearance to unventilated soffit *min. 25-1/2” (65 cm) *min. 25-1/2” (65 cm)
from the centerline of the terminal.
____________________________________________________________________________________________________
F=Clearance to outside corner
*min. 10”/25cm *min. 10”/25cm
from the centerline of the terminal.
____________________________________________________________________________________________________
G=Clearance to inside corner
*min. 16”/40cm *min. 16”/40cm
the centerline of the terminal.
____________________________________________________________________________________________________
H= Clearance to each side of centerline
3’ (91cm) w ithin a height 15’ (4.5m) *
extended above meter/regulator assembly above the meter/regulator assembly
____________________________________________________________________________________________________
I= Clearance to service regulator vent outlet
3’ (91cm) *
____________________________________________________________________________________________________
J= Clearance to no mechanical air supply inlet
12” (30cm) 9” (23cm)
to building or the combustion air inlet to any
other appliance
____________________________________________________________________________________________________
K= Clearance to a mechanical air supply inlet
6’ (1.83 m) 3’ (91 cm) above if w ithin 10’ (3 m)
horizontally
____________________________________________________________________________________________________
L= Clearance above paved sidew alk or paved
7’ (2.13 m)† *
drivew ay located on public property
____________________________________________________________________________________________________
M = Clearance under veranda, porch, deck or
12” (30 cm)‡ *
balcony
____________________________________________________________________________________________________
1 In accordance w ith the current CSA B149.1, Natural Gas and Propane Installation Code
2 In accordance w ith the current ANSI Z223.1/NFPA 54, National Fuel Gas Code
† A vent shall not terminate directly above a sidew alk or paved drivew ay that is located betw een tw o single family dw ellings
and serves both dw ellings.
‡ Permitted only if veranda, porch, deck or balcony is fully open on a minimum of tw o sides beneath the floor.
* For clearances not specified in
ANSI Z223.1/NFPA 54 or CSA B149.1 , one of the follow ing shall be indicated:
a) A minimum clearance value determined by testing in accordance w ith section 2.23.7, or ;
b) A reference to the follow ing footnote: “Clearance in accordance w ith local installation codes and the requirements of the gas