76
Do not lay the wires parallel to
wire harnesses.
Connecting the loudspeakers
If passively pre-equipped with
4-ohm loudspeakers:
Adapt the ISO connector
7
of
the vehicle to the plug assign-
ment shown in the illustration
below.
If required, connect an ISO
extension cable (order no.
7 607 647 093).
Plug the connector into cham-
ber B
6
of the device.
If actively pre-equipped (separate
output stages):
Connect the special adapter ca-
bles to chamber C1 according
to the manufacturer's instruc-
tions.
Connecting the radio antenna
With pre-equipped vehicles, such as
VW, Seat or Audi, the supply voltage
for the antenna is supplied via the
antenna cable (see the operating
instructions of the vehicle). If the
original equipment radio of such a
vehicle is to be replaced by a com-
mercial radio, you must obtain an
antenna feed separating fi lter (or-
der no. 7 691 290 202) or the adapt-
➜
➜
➜
➜
➜
er cable (order no. 7 607 621 129)
from your specialist dealer.
The antenna installation and con-
nection is described in the antenna
installation instructions.
Insert the antenna connector
into the antenna socket
1
of the
device.
Connecting the GPS antenna
Install the GPS antenna in the ve-
hicle as described in the GPS an-
tenna installation instructions.
Insert the SMB connector
2
into
the corresponding socket of the
device.
Connecting the reversing light signal
Route the cable from the revers-
ing light to pin 3
3
of the connec-
tor in chamber A
5
so that +12 V
➜
➜
➜
➜
RR R
F LF
LR
4 Ohm
4 Ohm
4 Ohm
4 Ohm
+
-
+
-
+
-
+
-
A
6
7
1
2
Installation instructions
ROMENAV55Eman_star_ois_eng.indd 76
ROMENAV55Eman_star_ois_eng.indd 76
06.12.2005 16:04:50 Uhr
06.12.2005 16:04:50 Uhr