ENGLISH
E-11
Specifications
GENERAL
Dimensions
: Approx. 178 mm
×
50 mm
×
155 mm
(W
×
H
×
D)
Power requirements : 12 volts DC car battery
(negative ground)
Output Power
: 23 watts RMS
×
4 ch/45 watts peak
×
4 ch
Output Wiring
: Floating-ground type designed for 4
speaker use.
Output Impedance
: Compatible with 4-8 ohm speakers.
Low-Level Output
: 2 V.
TUNER
Tuning Range
: MW : 531 - 1,602 kHz (9 kHz step)
FM : 87.5 - 108,0 MHz (50 kHz step)
Sensitivity
: MW : 20
µ
V
FM : 9.1 dBf mono sensitivity
FM
Stereo Separation
: 35 dB
CASSETTE PLAYER
Frequency
Response
: 30 - 15,000 Hz
S/N Ratio
: 50 dB
Wow & Flutter
: 0.15 % WRMS
Troubleshooting Guide
The following check will assist in the correction of most prob-
lems which you may encounter with your unit. Before going
through the check list below, refer back to the connection and
operating procedures.
General
Radio reception
Also make sure that antenna is connected, extended and dry
inside.
If the above mentioned solutions do not help to improve the
situation, consult your nearest Blaupunkt dealer or in the
United States call 1-800-266-2528 for technical assistance,
parts and service. Call 1-800-950-2528 for dealer referral or
to request product brochure.
Cause/Solution
Leads are not matched
correctly with the car’s
accessory power
connector.
Check wiring for short
circuits.
The car doesn't have an
ACC position.
Trouble
• Memorized stations and
correct time are erased.
• The fuse has blown.
• Radio works when the igni-
tion key is the ON, ACC and
OFF positions.
• No power is being supplied
to the unit.
• The power is continuously
supplied to the unit.
Trouble
Preset stations are not re-
ceivable.
Seek tuning is not possible
Travel Store feature does
not complete storing of six
stations.
Cause/Solution
The broadcast signal is too
weak.
The broadcast signal is too
weak.
→
Use manual tuning.
Not enough broadcast frequen-
cies are receivable.
CD Changer Troubleshooting
When problems should develop while operating CD changer,
an error message appears in the display window.
Refer to the table below to identify the problem, then take the
suggested corrective action. If the error persists or “MECHA
ERR” and “09 ERROR” appears, contact your nearest
Blaupunkt dealer.
Message
NO MAG
NO DISC
CD ERROR
COMM ERR
TEMP ERR
Possible cause
No magazine.
No disc.
Up-side-down.
Focus error.
Communication error.
Excessive tempera-
ture conditions at the
CD changer.
Recommended action
Load the magazine in
the CD changer.
Check the disc.
Check the disc.
Check the connection
of the CD changer.
The error sign will go
o f f a n d p l a y w i l l
resume when the tem-
perature to a normal
range.
01-CC2̲SILVERSTONE(Eng)̲body
04.4.11, 2:27 PM
11