Blaupunkt Madrid RCM 105, Operating Instructions Manual, Page: 10 / 19

Madrid RCM 105 (Inland)
26
Changing the memory bank
You can shift between the memory banks I, II,
and T to store and recall preset stations.
The selected memory bank is indicated in the
display.
•
Press FM or TS until the desired me-
mory bank lights up in the display
(press repeatedly if necessary).
Storing stations
Using the preset buttons 1, 2, 3, 4, 5, 6 you
can store six stations on each FM memory
bank (I, II, T).
•
Select the waveband.
• Use the rocker switch to tune to a stati-
on (either automatically / or manu-
ally << >>).
• Press the desired preset button and
hold it down. The radio will be muted
and will resume play after approximate-
ly 2 seconds.
Now the station is stored. The activated pre-
set button is indicated in the display.
Note:
Should you tune into a station which has
already been stored, the corresponding pre-
set button and the memory bank will start
flashing in the display for a short while, if you
have selected another memory bank.
Adjusting the seek tuning sensi-
tivity
The set allows you to modify the seek tuning
sensitivity.
If “lo” is indicated, the radio will only pick up
strong stations (low sensitivity).
When switching on dx (“lo” goes out), the
system will also pick up less powerful stati-
ons (higher sensitivity).
To switch over:
•
Press lo or dx.
The degree of sensitivity can be separately
adjusted for both levels (see chapter “DSC
programming”).
Stereo - mono switch
You can switch to mono when the reception
quality becomes poor.
During mono reception the stereo symbol
in the display will go out.
To switch over:
•
Press lo for approximately 2 seconds.
Each time the car radio is switched on, the
radio will be automatically set to stereo re-
ception.
It will automatically switch to mono when the
reception quality becomes poor.
Storing the strongest stations
automatically with Travelstore
You can use the Travelstore memory bank to
automatically store the six strongest FM sta-
tions sorted on the preset buttons according
to their signal strength. This feature is espe-
cially useful when travelling, because it will
always give you the most powerful stations at
a fingertip as you pass through the various
reception areas.
•
Press TS for at least 2 seconds.
The radio will seek the six most powerful FM
stations and store them on the “T” memory
bank (Travelstore). As soon as this procedu-
re has finished, the first station will be played.
FM stations can also be stored manually on
the Travelstore memory bank (see “Storing
stations”).
Recalling stored stations
You can recall any stored station by pressing
the corresponding preset button.
•
Select the waveband using FM or TS.
• Briefly press the corresponding preset
button.