Blaupunkt LIVERPOOL 110, Operating And Installation Instruction, Page: 5 / 21

OPERATION
- In case of receiving a non RDS station
In radio mode:
-> CT ->FREQ -> ‘NO PTY’ -> "NO PS"
In CD mode:
-> CD -> CT -> FREQ -> ‘NO PTY’ -> "NO PS"
Each displaying time is several seconds, and
come back to 1’st position after several
seconds.
Notes:
- CT = clock time
- FREQ = frequency
SET THE TIME
(1) Manual setting:
Press and hold DSP button (11) for 2
seconds. The “HH” will flash. Press
button (23) or
button (24) to change
the hour. After that press DSP button the“MM”
will flash. Press button or
button to change the minute. Then press and
hold
DSP button to confirm.
(2) Auto setting:
To receive a RDS station which has good
signal(The AF symbol of the LCD does not
flashing). Several minutes later the time will
be synchronized to the correct time by the
station’s signal.(Note: None RDS station does
not have this function.)
EON on/off
In SEL menu You can set the EON on/off.
Normally set the EON to on.
LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated
functions on the display .
ESP FUNCTION
The unit can be shockproof between ten
seconds and twenty seconds.
RESET FUNCTION
RESET button (25) must be activated with
either a ballpoint pen or thin metal object.
The RESET button is to be activated for the
following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
Note: if press RESET button (25), the unit
can’t work yet, please use a cotton swab
soaked in isopropyl alcohol to clean the
socket on the front panel.
RADIO OPERATION

SWITCHING TO RADIO MODE
Press MODE button (21) to select radio
mode, the radio mode appears in the
display together with the memory band
and frequency.

SELECTING THE FREQUENCY BAND
At radio mode, press BAND button (19)
shortly to select the desired band.
The reception band will change in the
following order:
→
FM1
→
FM2
→
FM3
→
MW1
→
MW2

SELECTING STATION
Press button (24) or button
(23) shortly to activate automatic seek
function. It will search up/down a station
automatically. Press for 2 seconds until
“
MANUAL ” appears on the display, the
manual tuning mode is selected. In this
mode you can turn up/down a step
frequency one by one till searched a
station. If both buttons have not been
pressed for 5 seconds, it will return to seek
tuning mode and “
AUTO ” appears on the
display.

AUTOMATIC MEMORY STORING &
PROGRAM SCANNING
- Automatic memory storing
- Press AS/PS button (20) for 2 seconds,
the radio searches from the
5