Blaupunkt CS3010, Owner'S Manual

Page: 10 / 166

PREPARING THE MACHINE FOR OPERATION
The chain saw supplied by the manufacturer is partially disassembled. Information on the procedure
for changing the chain, mounting the guide bar, assembly drawings will allow you to assemble and
prepare the saw for work.
CHAIN BRAKE OPERATION
The safety brake is designed to stop the saw chain immediately upon kickback. The brake is ready for
use when it is in a vertical position.
Before each use of the saw, check the operation of the chain brake by moving the lever forward.
If the brake malfunctions have the saw serviced. Do not use the saw with an inoperative brake.
GUIDE BAR AND CHAIN INSTALLATION
CS3010 4010
Before installing/removing the guide bar and chain, make sure that the device is unplugged from
power source. Set the chain brake in a vertical position.
Take special care when operating the chain – it is extremely sharp. It is recommended to use protective
gloves.
Before installing the chain and guide bar, check the setting of the direction of the teeth. The saw
housing has an indication of the correct direction.
To remove the chain:
Unscrew the cover holding nut. Remove the transmission cover. Loosen the chain by turning the
counter-clockwise tensioning screw as far as possible. Remove the guide bar and chain.
To install the chain:
Unscrew the cover holding nut. Remove the transmission cover. Loosen the chain by turning the
counter-clockwise tensioning screw as far as possible. Insert the chain into the guide bar groove,
paying attention to the direction of the teeth, so that it corresponds to the indication on the housing.
Put the guide bar and chain onto the fasteners so that the drive links of the chain are in the teeth of the
drive wheel, the screw head in the longitudinal hole of the guide and the pin of the sliding tensioner in
the hole of the guide.
It is recommended to change the position of the guide once every 5 hours of operation so that the
upper edge and the lower edge wear evenly.
Each time, check that the oil passage is clean and ensures free flow.
TENSIONING THE CHAIN
Before starting work, tension the chain. To do so, use the chain tension nut. Tension the chain
clockwise.
8