ENGLISH
E-10
Specifications
GENERAL
Dimensions
: Approx. 178 mm
×
50 mm
×
155 mm
(W
×
H
×
D)
Power requirements : 12 volts DC car battery
(negative ground)
Output Power
: RMS and Peak Power ratings (188
watts)
BPV 655
220 watts/55 peak
×
4ch
BPV 650
200 watts/50 peak
×
4ch
Output Wiring
: Floating-ground type designed for 4
speaker use.
RCA low-level outputs (2 channels).
Output Impedance
: Compatible with 4-8 ohm speakers.
Low - Level Output
: 2 V.
TUNER
Tuning Range
: AM : 530 - 1,710 kHz (10 kHz step)
FM : 87.5 - 107.9 MHz (200 kHz step)
Sensitivity
: AM : 20 µV
FM : 9.1 dBf mono sensitivity
FM
Stereo Separation
: 35 dB
CD PLAYER
Frequency
Response
: 20 - 20,000 Hz
S/N Ratio
: 98 dB
Wow & Flutter
: Below the measurable limit
Troubleshooting Guide
The following check will assist in the correction of most prob-
lems which you may encounter with your unit. Before going
through the check list below, refer back to the connection and
operating procedures.
General
Radio reception
Also make sure that antenna is connected, extended and dry
inside.
If the above mentioned solutions do not help to improve the
situation, consult your nearest
Blaupunkt
dealer or in the
United States call 1-800-266-2528 for technical assistance,
parts and service. Call 1-800-950-2528 for dealer referral or
to request product brochure.
Cause/Solution
Leads are not matched
correctly with the car’s
accessory power
connector.
Check wiring for short
circuits.
The car doesn't have an
ACC position.
Trouble
• Memorized stations and
correct time are erased.
• The fuse has blown.
• Radio works when the igni-
tion key is the ON, ACC and
OFF positions.
• No power is being supplied
to the unit.
• The power is continuously
supplied to the unit.
Trouble
Preset stations are not re-
ceivable.
Seek tuning is not possible
Travel Store feature does
not complete storing of six
stations.
Cause/Solution
The broadcast signal is too
weak.
The broadcast signal is too
weak.
→
Use manual tuning.
Not enough broadcast frequen-
cies are receivable.
CD Player Troubleshooting
When problems occur with CD playback, an error message
appears in the display window.
Refer to the table below to identify the problem, then take the
suggested corrective action. If the error persists, contact your
nearest
Blaupunkt
dealer.
Message
Possible cause
Recommended action
E-01
Dirty disc.
Clean the disc.
Scratched disc.
Replace the disc.
Up-side-down.
Check the disc.
E-02
Focus error.
Try ejecting and re-insert-
ing under normal tempera-
ture conditions.
E-03
Data and focus error. Under normal temperature
conditions, eject and insert
clean, undamaged disc
properly.
E-04
Mechanical problem.
Eject and re-insert.
E-05
Loading/Eject error.
Eject and re-insert.
BPV655(EN)_body
2002.06.17, 14:33
10