Blaupunkt Avignon RCM 127, Operating Instructions Manual, Page: 14 / 23

33
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
• Press the corresponding preset button
briefly to recall the station.
Scanning stored stations with
Preset Scan
You can have all of the stored stations briefly
scanned.
To start Preset Scan:
•
Press SC/SRC for approximately
1 sec. until “SCAN” appears in the dis-
play.
All of the stored stations to be received in
the selected waveband will be scanned one
after the other. On FM, the radio will either
scan the stations stored on memory bank I
and II or T.
To select a scanned station and switch
off Preset Scan:
•
Press SC/SRC for about 1 second.
Note:
If “TA” shows on the display panel, the sys-
tem will scan the stored traffic stations only.
Selecting the seek tuning sensi-
tivity
You can alter the automatic seek tuning
sensitivity.
If “lo” is displayed, the radio will only pick up
strong, local stations.
Note:
Should you tune in a station which has al-
ready been stored before, then the corre-
sponding preset position and memory bank
will briefly flash in the display.
Automatically storing the
strongest stations with Travel-
store
You can automatically store the five most
powerful FM stations of your current recep-
tion area sorted according to their signal
strength. This function is particularly conven-
ient on longer trips.
•
Press the TS/BND button for 1 sec.
“T-STORE” will appear in the display.
The five strongest FM stations will be auto-
matically stored on the memory bank “T”
(Travelstore). When this process has been
completed, the radio will play the first sta-
tion stored on preset 1.
If desired, stations can also be stored man-
ually on the Travelstore bank (see “Storing
stations”).
Recalling stored stations
You can recall any stored station at the touch
of a button.
•
Select the memory bank with TS/BND.
If “lo” does not light up, the radio will also
pick up weaker, distant stations.
Should you wish to alter the seek tuning
sensitivity, refer to chapter “DSC program-
ming – LO/DX”.
Stereo - mono switching
The radio will only play in stereo if the ster-
eo quality of the received station signal is
sufficient.
When the signal strength gets poor, the ra-
dio will gradually switch to mono.
You can select between stereo or mono
sound in the DSC menu.
For more information, refer to chapter “DSC
programming – STEREO/MONO”.
Each time the radio is switched on, stereo
sound is activated automatically.
Loudness
If the system is played at a low volume lev-
el, the Loudness function creates a more
natural sound by boosting the low frequen-
cy range.
To turn Loudness on/off:
•
Press AUD for about 1 second.
“LD” appears in the dislay, if the Loudness
function is activated.
For more information please refer to “DSC
programming”.
Avignon RCM127 gb 15.05.2002, 12:16 Uhr 33