Blatchford Orion3, User Manual

Page: 10 / 72

938375V2APK3/1-0321
10
To check the battery condition press and hold the
[
-
]
button on the knee, one short beep will be
heard and the LED will indicate the battery condition.
When fully charged the device battery is intended to provide 3 days of normal use (conditional
on the type of use). We recommend that the knee be fully charged every night. Switching off the
device when not in use will also prolong the period of use
Note… The device will take 30 seconds to reset after it is switched back
ON [ I ],
refer to Section 6
‘Battery Charging (continued)’ for the reset sequence.
Battery Charge Indicator
LED Beeps Battery Condition
Green 3 flashes -- fully charged
Green 2 flashes -- good
Green 1 flash -- ok
Yellow slow flash 8 x Short beeps low charge
Red slow flash 5 x Long beeps no charge
6.1
Magnetic Charger Connection
6.2 Battery Status
Please check for any misalignment between mating surfaces
as this may result in no charging. This can happen especially
when the charging setup puts strain on the charging cable
(Figure 3).
Before charging ensure charging surfaces are clean, dry and
free of any debris.
Do not allow any ferrous material to attach itself to the
charging surfaces.
Keep the magnetic surfaces away from materials that may
be adversely affected by their proximity to strong magnetic
fields (e.g. watches, pacemakers, bank cards or magnetically
stored media).
Prevent build up of debris on the charging surfaces as this
may prevent charging or damage the charger. Disconnect the
charger from the mains socket and remove any debris before
reconnecting the charger to the device.
Note… The connector and the terminal are not polarized so
orientation is not critical (Figure 2).
The charging connector can be connected to the device through the charging terminal located
at the posterior of the knee.
The connector and the terminal magnetically lock together and correctly self-align on
connection (Figure 1).
Device
Device
LED
1
.
2 .
3.