4
Installation
Positioning the machine
When determining where to install your machine, take care to choose a place where you can easily load and
unload it. Make sure not to install the machine where there is the possibility that the ambient temperature will
fall below 0°C.
Before installing, take the machine out of its packaging by following the warnings located on the packaging.
Do not grip the machine by its door in order to move it.
Position the machine close to a water tap or drain. Make sure that the water inlet and outlet hoses do not get
squeezed whilst positioning the machine. Also ensure that the machine does not rest on the power cable.
Use the machine’s adjustable feet to ensure that it is level and balanced. Proper positioning of the machine
ensures problem-free opening and closing of the door.
Water connection
Be sure that the indoor plumbing in the place of installation is suitable for a dishwasher. It is recommended
that you fit a filter on the inlet hose to the machine, as this can reduce the risk of damage to the machine due
to contaminants in the water (sand, clay, rust etc.). This can also reduce yellowing and formation of deposits
after washing.
Water Inlet Hose
Do not use the water inlet hose of your old machine. Before connecting the inlet
hose, run water through it for a while before making the connection. Connect the
water inlet hose directly to the water inlet tap. The pressure supplied by the tap
should be at a minimum of 0.03 MPa and at a maximum of 1 MPa. If the water
pressure is above 1 MPa, a pressure-relief valve should be fitted in between.
After the connections are made, the tap should be turned on fully and checked for
water tightness. For the safety of your machine, make sure to always turn off the
water inlet tap after each wash program is finished.
NOTE
: Aquastop water spout is used in some models. In the case of using
Aquastop, a dangerous tension exists. Do not cut Aquastop water spout. Do
not let it get folded or twisted.