BlackVue DR900S-1CH, Manual

Page: 15 / 100

DR900S-1CH
15
6
Turn on the engine. The BlackVue dashcam will power up and start recording. Video files are stored on the microSD card. When the
microSD card fills up, the newest video files will start to replace the oldest video files (called
loop recording ) – so you will always
have the most recent video files.
7
Turn off the engine. The dashcam will automatically stop recording and power down. To record in parking mode while the engine is
off please install a
Power Magic Battery Pack
(sold separately) or a
Power Magic Pro
(sold separately). A
Power Magic Pro
powers
your dashcam when the engine is off by hardwiring it to the automotive battery. A low voltage power cut-off function and a parking
mode timer protect the automotive battery from discharge.
Note
y
Up to 50 event recordings (impact, manual) can be locked from being overwritten. By default, this feature is disabled. You can
enable it from firmware settings and choose to either overwrite them with new event files when the event file storage is full
or lock the 50 event files and save the new event files in loop recording storage. Please note that formatting the microSD card
deletes all the recordings including the locked event files.
y
The recording LED blinks while recording (default setting) and the GPS LED is on when a GPS signal is received. There are 4
recording modes: Normal, Event, Parking and Manual. The dashcam starts recording in normal mode, switches to event mode
when an impact is detected, and switches to parking mode if the vehicle is stationary for 5 minutes. Touching the proximity
sensor turns on/off audio recording or triggers manual recording depending on the firmware settings.
y
When you run the dashcam for the first time the firmware is automatically loaded onto the microSD card. After the firmware has
been loaded onto the microSD card you can customize settings using BlackVue Viewer on a computer.
ENGLISH