4
Secure the legs to the chassis with the leg fastening screws and tighten the screws to
a torque of 35 Nm.
The side cover for each leg can be reattached later. Leaving the cover off at this point
of assembly provides access to the inside of the leg for when you are wiring up the
panels inside the console.
5
Carefully lower the console from the support surface and place it on the floor.
We recommend placing the assembled chassis as close to its intended position as
possible, as once Fairlight modules are installed, the overall weight of the unit will
increase substantially. Ensure there is enough space at the rear of the chassis to
replace the back panel before securing your console into position.
Alternative Assembly with Two or More People
If you don't have access to a scissor lift trolley or similar utility and have someone to help you,
you can stand the chassis on its rear panel and attach the legs and feet from this position.
To assemble the legs and feet:
1
After removing the console chassis from its road case, gently lean the chassis onto its
rear panel. Ensure a second person holds the chassis in place so it does not slip.
Lean the console chassis onto its rear panel so the front is facing upwards
2
With the console chassis securely held in place, attach the legs as shown in the
previous section.
9
Unpacking and Assembling
