11
Testing your Blackmagic Shield and Library Installation
You can choose from the following video output formats:
720p50
720p59.94
720p60
1080i50
1080i59.94
1080i60
1080p23.98
1080p24
1080p25
1080p29.97
1080p30
1080p50
1080p59.94
1080p60
Programming Arduino Sketches
The programs, or sketches, written into the Arduino software are very easy to write! Sketches
are written using common ‘C’ programming language. When programming your sketches using
commands from the Studio Camera Control Protocol, the shield embeds these commands into
the SDI output which lets you control your Blackmagic URSA Mini or Blackmagic Studio Cameras.
All supported commands are included in the Studio Camera Control Protocol section of this
manual so you can take the commands from the protocol and use them in your sketch.
Testing your Blackmagic Shield
and Library Installation
After everything is connected as described in the ‘Getting Started’ section and you have
installed the setup software and library files, you’ll want to check that your shield is
communicating with the Arduino board and that everything is working as it should.
A fast way is to open and run the supplied tally blink example sketch.
To do this:
1
Launch the Arduino IDE software.
2
Go to the ‘tools’ menu and select the Arduino board and Port number.
3
From the ‘File’ menu, select ‘Examples/BMDSDIControl’ and choose the sketch
named ‘TallyBlink’.
4
Upload the sketch to your board.
Summary of Contents for Design 3G-SDI Arduino Shield
