Blackboard LC3000, Installation And Setup Manual

Page: 26 / 43

W
I R E L E S S
L
A U N D R Y
S
Y S T E M
I
N S T A L L A T I O N
O
V E R V I E W
Laundry Installation and Setup Guide
26
W
I R E L E S S
L
A U N D R Y
S
Y S T E M
I
N S T A L L A T I O N
O
V E R V I E W
When configuring an LWI for a stacked dryer unit, enter the odd number for the lower half of the stack dryer.
The LC3000 will internally configure the upper (even-numbered) half of the stack dryer unit. For example, a
Maytag Stack Dryer, labelled as machines 3 and 4, lower and upper halves respectively, would specify
machine number 3 as the half requiring configuration.
Install the LWI30XX in Laundry Machines
Before installing the LWI30XX inside a laundry machine, the module must be configured (see Configure the LWI30XX
for Laundry Machines (page 25). Verify the completion of this step before attempting to install the LWI30XX. Also ensure
the machine number assigned to the LWI30XX during the configuration process matches the number assigned to the
laundry machine. The machine number should be recorded on the label of the LWI30XX wireless module.
For any installation, either the hood or front panel of the laundry machine must be removed to gain access to the
electronic control board. Consult the manufacturer’s manual for steps to perform this task. Each LWI30XX contains a
wiring harness for connecting the wireless module to the laundry machine’s control board. All wiring harnesses support
both single and stacked machines. When performing an installation for a single machine, some connectors may not be
used.
In a typical installation, the wireless module can be installed inside the machine. However, if the laundry machine is more
than 50 feet from the LE3/BRIDGE, it may be necessary to mount the module on the outside of the laundry machine for
best reception. Sheet metal screws are provided with the LWI30XX to attach the module.