Page 13 of 17
Duty Cycle (Duration of Use):
Avoid damage to the winch by not winching for more than
the prescribed duty cycle time. The Duty Cycle defines the
amount of time, within a 15-minute period, during which a
winch can operate at its maximum capacity without
overheating. For example, this winch with a 5% duty cycle
at 65% maximum load must be allowed to rest for at least
14 minutes, 15 seconds after every 45 seconds of
continuous operation. Failure to carefully observe duty
cycle limitations can easily over-stress a winch, causing
premature winch failure. Do not attempt to pull full-rated
load for more than 20 seconds. Release Power-In switch
immediately when winch drum/rope stops. Allow winch to
cool and change rigging as needed before continuing pull.
After Each Use
•
Inspect rope for damage. Replace immediately if damaged.
•
Wipe external surfaces of the winch with a clean cloth.
Maintenance
⚠
WARNING
•
To prevent serious injury, disconnect the battery cables before performing any inspection,
maintenance, or cleaning procedures.
•
To prevent serious injury from winch failure, do not use damaged equipment. If an
abnormal noise or vibration occurs, have the problem corrected before further use.
•
When operating a steel cable winch, be sure to check and maintain cable. Maintenance
may include lubricating rope occasionally with a light oil.
•
The winch’s internal mechanism is permanently lubricated. Do not open the housing.
However, if the winch is submerged, it should be opened, dried, and re-lubricated by a
qualified technician as soon as possible to prevent corrosion.
Rev. 032521 DiscountRamps.com 1-888-651-3431 Page 13