■
On the back of the remote, press
the release button on the bottom
right hand side. This will allow
the tray containing the battery to
be released. Release the tray by
squeezing the small lip and pulling
down the tab at the bottom of the
remote (Fig. 2).
■
Replace the battery with one new
CR2032 button battery. Important:
Install only new batteries of the
same type in your product. Failure to insert batteries
in the correct polarity, as indicated in the battery
compartment, may shorten the life of the batteries or
cause batteries to leak. Do not mix old and new bat-
teries. Do not mix Alkaline, Standard (Carbon-Zinc)
or Rechargeable (Nickel Cadmium) or (Nickel Metal
Hydride) batteries. Danger of explosion if battery is
incorrectly replaced.DO NOT DISPOSE OF BATTERY IN
FIRE, BATTERY MAY EXPLODE OR LEAK
■
This product contains a button cell battery. If swal-
lowed, it could cause severe injury or death in just 2
hours. Seek medical attention immediately.
This product contains a button battery. If swallowed, it could cause severe injury
or death in just 2 hours. Seek medical attention immediately.
Blackstone International Ltd. and other trademarks are the property of the respective owners. All other brand names
and logos are registered trademarks of their respective owners.
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired
operation. Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC rules and Industry Canada ICES-003. These
limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a
residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
Note: This device complies with part 15 of the FCC rules and
Industry Canada ICES-003. Operation is subject to the following
two conditions: (1) This device may not cause harmful interfer-
ence, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CLEANING AND STORAGE
■
■
Use a soft cloth to wipe the housing. DO NOT use water
or any other chemical solution or cleaner. DO NOT soak
or immerse the fan in water or liquid.
■
DO NOT ATTEMPT TO TAKE THE FAN APART.
■
Store in a dry place away from excessive heat and direct
sunlight.
■
Regular cleaning will ensure optimum performance and
appearance of the fan.
■
DO NOT kink the power cord when storing or while in use.
TROUBLESHOOTING
HAVE A PROBLEM? PLEASE CONTACT CUSTOMER SERVICE.
Should you have any questions or comments please contact us at: [email protected]
WARRANTY:
This fan includes a one (1) year warranty, which covers manufacturer defects and workmanship under normal use.
Warranty is offered only to the original purchaser. Proof of purchase is required. Proof of purchase constitutes a dated sales
receipt. This warranty is void if the fan(s) have been subject to abuse such as: being dropped which could result in damage
to the fan cabinets, motors, fan controls, etc. immersion in or exposure to water, exposure to excessive heat, outdoor usage,
any use other than household use, disassembly, repair or alteration by anyone other than an authorized service provider, use
on improper voltage or current, or any use contrary to the user instructions. Batteries and battery life are not covered in this
warranty. DO NOT attempt to repair any electrical or mechanical functions of this product; doing so will void this warranty and
could lead to injury.
MADE IN CHINA |
Distributed by: Blackstone International, Ltd.
A.
To disconnect, grasp the plug and pull it from the wall outlet. DO NOT unplug by pulling the cord.
B.
Open fuse cover. Slide open the fuse access cover located on the top of the plug towards the plug
blades.
C.
Remove the fuse by turning the fuse over (end over end) carefully making sure not to break the fuse.
(See Fig. 2)
D.
E.
Close fuse cover. Slide close the fuse access cover toward the fan cord on the top of the plug.
F.
The fan plug uses a 5 amp fuse.
G.
In the event of loss of power please check the fuse located within the plug.
Fig. 1
Fig. 2
Fig. 3
Problem
■
Fan does not operate
Possible
Cause
■
Plug is not fully
inserted into wall
■
Fuse in plug is tripped
Solution
■
Make sure plug is fully plugged
into wall
■
Replace fuse
FCC STATEMENT OF COMPLIANCE
REMOTE CONTROL BATTERY REPLACEMENT
USER SERVICING INSTRUCTIONS
OSCILLATING FAN
INSTRUCTION
MANUAL
MODEL: CCF-21-SG,
CCF-21-CG,
CCF-21-P, CCF-21-W,
CCF-21-B
VOLTAGE: 120V AC
FREQUENCY: 60Hz
CURRENT: 52 W
IMPORTANT, RETAIN FOR FUTURE REFERENCE:
READ CAREFULLY | FOR HOUSEHOLD USE ONLY
Use Only With a Fuse Rated 5 Amperes, 125 Volts.
Fig. 1 Fig. 2
●
●
●
●
