12
CYCLONIC FILTER
To remove the cyclonic filter
23. Open the lid by pulling the catch at the end of the handle and remove the filter.
24. Grasp the top part of the cyclonic filter and pull it out.
25. Clean cyclonic filter and filter screen using a small brush. If needed, wash with mild soap and rinse with
cold tap water. Do not use any abrasive cleaners.
26. Shake excess water from cyclonic filter and let it dry completely before inserting back into the unit.
To replace cyclonic filter
27. Insert the cyclonic filter into the dust collector and aline the tab on the top of the filter
with the slot on dust collector.
28. Insert the filter back into the dust collector and close the lid.
29. Insert dust collector back in canister compartment.
Tip:
Pull on the handle to verify that it is secured in place.
HEPA GRADE INTAKE FILTER
The HEPA grade intake filter is located at the top of the dust collector inside the lid.
30. Open the lid by pulling the catch at the end of the handle.
31. Remove the filter by pressing the lock tab.
32. Clean the sponge and the filter with soap and water, and allow to dry before reinstalling.
33. Insert filter back into the dust collector or replace with a new filter and close the lid.
34. Insert dust collector back in canister compartment.
HEPA EXHAUST FILTER
The HEPA exhaust filter is located at the back of the canister.
35. Push down the left the locking clip on the exhaust filter cover and pull out.
36. Grasp the HEPA filter and pull out.
37. Clean the HEPA filter with soap and water, and allow to dry thoroughly before reinstalling.
38. Insert the HEPA filter back into the canister or replace with a new filter and snap cover back in place.
