ENGLISH • 9
Labels on tool
The label on your tool may include the following symbols:
FEATURES (Fig. A)
1. On/Off switch
2. Bowl release button
3. Charging indicator
4. Charging socket
5. Dust bowl
6. Wet/Dry foam insert
7. Wet/Dry filter
8. Squeegee
9. Charger
10. Jack plug
11. Wall mount bracket
ASSEMBLY
Wall mounting
The product can be wall mounted, if desired, using
the wall mount bracket, screws and anchors supplied.
To wall mount the vac, refer to Figs. B, C, D and E.
f
Figure B: Mark the location of the screw holes
(within reach of an electrical outlet for chargeing
the vac while it is on the wall bracket).
f
Figure C: Insert the charger cord into the curved slot
in the wall mount bracket leaving approximately
8-9 inches (203mm - 227mm) excess as shown.
f
Figure D: Hang the vac on the wall by placing
the opening on the base of the vac over the hooks
in the wall mount bracket as shown in Fig. D.
f
Figure E: Insert the jack plug into the charging socket.
Charging the battery
From new, the rechargeable cells of the product need
a minimum charge time of 9 hours to ensure full power.
We suggest you fully discharge the product when it is used
for the first time as this will help the cells recharge faster.
f
The switch must be in the off (“O”) position,
the product will not charge if it is in any other position.
f
Figure F: Plug the jack plug of the charger into
the charging socket of the tool. Plug the charger into
any standard electrical outlet. The charging indicator
will be lit. While charging, the charger may get warm,
this is perfectly normal and safe. It is safe to leave
the appliance connected to the charger indefinitely.
The charger automatically reduces power
consumption when charging is complete.
f
When charging is complete, the LED will turn off.
Warning! Do not charge the battery at ambient
temperatures below 39°F (4°C) or above 104°F (40°C).
USE
Switching on and off
f
Figure G: To start, slide the On/Off switch forward
(i.e. “O”= Off, “I” = On).
f
To stop, slide the switch back.
f
Return the product to the charger immediately after
use so that it will be ready and fully charged for
the next use. Ensure that the product is fully engaged
with the power supply plug.
Dry pick-up
f
For everyday spills of dry material.
Wet and dry pick-up
f
For everyday spills of dry material, use your appliance
without the squeegee accessory.
Caution! Your product is designed for light spills only.
f
This vacuum can also be used to pick up everyday
liquid spills. Use the squeegee accessory on non-
absorbent, hard surfaces. On absorbent surfaces,
such as carpet, your appliance will pick up wet spills
better without the accessory.
f
For best performance on hard surface wet pickups,
insert squeegee into the bowl nozzle opening.
f
For best results when using this accessory, hold
the appliance at an angle of 45° and pull it slowly
towards you.
f
Do not fill the bowl beyond the end of the intake chute.
If there is any liquid in the bowl, do not turn the unit
upside down, sideways, point the nozzle upward,
or shake the vac excessively.
f
After picking up liquid substances clean the vac
and filter immediately. Mold and mildew may form if
the unit is not properly cleaned after wet pickups.
f
If charging in a vertical position, be sure to empty all
liquid contents to avoid damage to your appliance.
Cleaning the product
Warning! Never use the vac without its filter.
Note: The filter is re-usable, do not confuse it with
a disposable dust bag, and do not throw it away when
the product is emptied. We recommend that you replace
the filter every 6-9 months depending on frequency of use.
Read
Instructions
Manual
Use Eye
Protection
Use Ear
Protection
V ........ Volts
A ........ Amperes
Hz ....... Hertz
W ........ Watts
min ..... minutes
..... Alternating
Current
..... Direct
Current
n
0
....... No-Load
Speed
...... Class II
Construction
.... Earthing
Terminal
.... Safety Alert
Symbol
.../min.. Revolutions
or Recipro-
cation per
minute
