Black Box Zero Client S100, User Manual, Page: 6 / 124

RDS Solution With vMatrix User Manual
2
Safety Information
Refer to the following information to prevent any physical injury or loss of assets caused
by damage to the product. A user must read this User Guide carefully before use and
properly follow the instructions.
⚫
Make sure that the place of installation is not too hot (above 35°C), too cold (below 0°C),
or too wet (above 85% relative humidity).
⚫
Avoid any severe impacts to the product
⚫
Make sure that the product is not exposed to direct sunlight or any hot machinery.
⚫
Please keep the product away from any items which have strong magnetic properties.
⚫
Do not disassemble, repair or rebuild the product.
⚫
Please properly route all cables and power cords to avoid a tripping hazard. An electric
shock, fire, damage to the product or physical injury may occur as a result of tripping
over the cable.
Regulatory Compliance
FCC Information
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try and correct the interference by one or
the following measures:
⚫
Reorient or relocate the receiving antenna
⚫
Increase the separation between the equipment and the receiver
⚫
Connect the equipment to a power outlet on a circuit different from which the receiver
is connected
⚫
Consult your dealer or an experienced radio TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.