®
5V
1A
4
3
2
Ind
oor
us
e o
nly
Keyboard and mouse connections
To connect a keyboard and mouse
1 At the rear panel of the ServSwitch TDX unit, attach the connector from the
keyboard to the purple socket that is closest to the power input socket.
2 At the rear panel of the ServSwitch TDX unit, attach the connector from the
mouse to the green socket that is closest to the power input socket.
Remote control connections
The remote control unit can be used to provide manual switching between
systems.
Note: The remote control cannot be used in conjunction with the ServSwitch
TDX when a Synchrony auto switching link is being used because they both use
the same switching socket.
To connect the remote control
1 On the underside of the ServSwitch TDX unit, ensure that switch 5 is
switched OFF.
Note: The switch settings are consulted by the unit only
during its power up phase, i.e. when power is first supplied by a keyboard
socket of a powered system. Therefore, change the setting while the unit is
disconnected or use switch 8 to force a reset, whereupon the other switches
will be consulted.
2 Locate the remote control unit and the remote control cable. Attach the
smaller of the two cable connectors to the socket at the rear of the remote
control.
3 At the other end of the cable, attach the larger connector to the socket on
the end of the ServSwitch TDX unit.
Optional power supply connections
Note: The ServSwitch TDX can obtain its power from the keyboard connections
of any of the four connected systems. Thus, an external power supply is not
required unless the connection cables used exceed 2 metres.
Important: Please read and adhere to the electrical safety information given
within the
section of this guide. In particular, do not use an
unearthed power socket or extension cable.
To connect the optional power supply
1 Attach the output connector of the power supply (country specific power
supplies are available) to the socket on the far left of the rear panel of the
ServSwitch TDX.
2 When all other connections have been made, connect the main body of the
power supply to a nearby earthed mains socket.