Black Box ServManager SW995A-R2, Manual

Page: 14 / 86

15
CHAPTER 2: Introduction
Panel Label Connector Description
CPU N DB25 F For each submaster you plan to connect, you
(continued)
must have an Expansion Cable; you must have
an Adapter Cable for each CPU you plan to
connect. See
Section 2.5 .
NOTE
All models share the same chassis, which
has 16 CPU
N connector slots. The extra
connector slots in the chassis of the 4-,
8-, and 12-port models are left blank, but
are protected by material mounted inside
the chassis.
MONITOR/ DB25 F Connect the shared monitor, keyboard, and
KEYBOARD/ mouse to this port using an “MKM Adapter
MOUSE Cable.” At the ServManager end, this cable has
a DB25 male connector; at the other ends, it has
appropriate connectors to plug into your
monitor, keyboard, and mouse cables. Only one
MKM Adapter Cable is needed. See
Section 2.5 .
RS232 RJ-12 F If you connect a more distant computer or
terminal to this RS-232 serial port, you’ll be able
to send switching commands to the ServManager
from a secondary location. You would also
connect a computer to this port to load firmware
upgrades into the ServManager.
POWER 5-pin Connect the ServManager’s power-supply cord
DIN F here. This is not a keyboard input. Power
transformers are available for 110 VAC or
230 VAC. They have center-tapped output of 17
VAC at 1.4 amps.