Black Box Power View PS570A, Installation And Operation Manual, Page: 23 / 32

Administration Commands
System Administration
Displaying the Power View Enhanced PDU firmware version
The Version command displays the firmware version.
To display the firmware version:
At the Power View Enhanced PDU: prompt, type version and press Enter .
Performing a warm boot
The Restart command performs a warm boot.
NOTE: System user/outlet/group configuration or outlet states are NOT changed or reset with this command.
To perform a warm boot:
At the Power View Enhanced PDU: prompt, type restart and press Enter .
TCP/IP Administration
NOTE: A restart is required after setting or changing ANY TCP/IP configurations. See Performing a warm boot on page 19
for more information.
Setting the IP address
The Set Ipaddress command sets the TCP/IP address of the network interface controller.
To set the IP address:
At the Power View Enhanced PDU: prompt, type set ipaddress , followed by the IP address and press Enter .
Example
The following command sets the IP address to 12.34.56.78:
Power View Enhanced PDU: set ipaddress 12.34.56.78<Enter>
Setting the subnet mask
The Set Subnet command sets the subnet mask for the network the Power View Enhanced PDU will be
attached to.
To set the subnet mask:
At the Power View Enhanced PDU: prompt, type set subnet , followed by the subnet mask and press
Enter .
Example
The following command sets the subnet mask to 255.0.0.0
Power View Enhanced PDU: set subnet 255.0.0.0<Enter>
Setting the gateway
The Set Gateway command sets the IP address of the default gateway the Power View Enhanced PDU
uses to access external networks.
To set the gateway IP address:
At the Power View Enhanced PDU: prompt, type set gateway , followed by the gateway IP address and press
Enter .
Example
The following command set the gateway IP address to 12.34.56.1:
Power View Enhanced PDU: set gateway 12.34.56.1<Enter>
Power View Enhanced PDU Operations
•
19
Installation and Operations Manual