63
CHAPTER 10: Configuring Management Functions
10. Configuring Management
Functions
The Management menu is used to select the desired management interface
type and to set up the necessary parameters for establishing TELNET or
SNMP management. See Figure 10-1 for the Management menu tree.
Figure 10-1. Management Menu Tree.
10.1 Interface
Select the management interface type (VT100 terminal, SLIP, or PPP) or select
Ethernet LAN (the SNMP Ethernet Module must be installed).
10.2 Control Rate
Select the control port operating speed to match the connected device (this
selection only applies when the interface options is set for VT100 terminal, SLIP,
or PPP).
3=CONFIG
1=LOCAL
2=REMOTE ENTER ADDRESS
1=NETWORK OPT.
2=DTE OPTIONS
3=TEST OPTIONS
4=DIAL OPTIONS
5=MANAGEMENT
6=UTILITIES
1=INTERFACE
2=CONTROL RATE
3=IP OPTIONS
4=SNMP OPTIONS
5=TELNET OPTIONS
1=TELN PASSWORD
2=TELNET TIMEOUT
1=VT 100 CONTROL
2=SLIP CONTROL
3=PPP CONTROL
4=ETHERNET LAN
1=1200 BPS
2=2400 BPS
3=9600 BPS
1=UNIT IP ADR
2=SUBNET MASK
3=GATEWAY IP ADR
4=IP SECURITY
5=IP FILTER ADDR
1=GET COMMUNITY
2=SET COMMUNITY
3=TRAP COMMUNITY
4=SNMP TRAPS
5=TRAP IP ADR
6=SYS NAME
7=SYS CONTACT
8=SYS LOCATION
9=AUTHEN TRAPS
1=DISABLED
2=ENABLED
ENTER SOURCE IP
NUMBER (1-5): 1
1=DISABLE
2=GENERIC ONLY
3=ENABLE ALL
ENTER TRAP IP
NUMBER (1-5): 1
1=DISABLED
2=ENABLED
1=10 MINUTES
2=30 MINUTES
3=60 MINUTES