Figure C-5. Main Configuration Menu.
C.2.1 DSU C
ONFIGURATION
(DTE, N
ETWORK
,
AND
T
EST
O
PTIONS
)
Chapters 6–9 include detailed descriptions of these parameters. See Figure C-6.
Figure C-6. DSU Configuration Menu.
C.2.2 DBU C
ONFIGURATION
This menu changes depending on which DBU card is installed. See the chapter
Configuring Dial Options for more information. The menu for the S4W DBU card
is shown in Figure C-7.
NOTE
If DBU Configuration is selected when no DBU card is installed, the
message “CSU/DSU MS DBU DBU NOT INSTALLED” appears. Press the
ESC key to return to the previous screen of selections. If this message
is received when a card is installed, make sure that the card is properly
seated in the slot and then restart the unit.
103
APPENDIX C: Terminal Menu Structure
1 DSU
2 DIAL BACKUP
3 DIAL DIRECTORY
4 MANAGEMENT
5 UTILITY
CONFIGURATON MENU
ESC = EXIT ENTER SELECTION -> _
DTE OPTIONS
NETWORK/TEST/COMMANO OPTIONS
1 DTE RATE (@56K/64K) = SAME AS LOOP 14 LOOP RATE = AUTO
2 CONNECTOR TYPE - V.35
15 NETWORK ADDRESS =0
3 DTE DATA FORMAT = SYNCHRONOUS
16 NETWORK TYPE = DEDICATED
4 ASYNC WORD LENGTH = 10 BITS
17 CLOCK SOUREC = FROM NETWORK
5 DTE CMD SET = DIS
18 TEST TIMEOUT = 0
6 TRANSMIT CLOCK = NORMAL
19 REMOTE TEST = EN
7 CS CONTROL = FOLLOWS RS
20 LL EIA = DIS
8 RS-CS DELAY = SHORT
21 RL EIA = DIS
9 ANTI-STREAM = TIMER OFF
22 REMOTE CONFIG = EN
10 CO CONTROL = NORMAL
23 SW56 AUTO ANSWER = EN
11 TR CONTROL = IGNORED
12 SR CONTROL = OFF TEST+00S
13 SCRAMBLE (64K) = OFF
DSU CONFIGURATON
ESC = EXIT ENTER SELECTION -> _