Black Box LE2700A, User Manual, Page: 115 / 154

724-746-5500 | blackbox.com
Page 115
Chapter 5: Management
5.9 Alerts
5.9.1 Fault Alarm
When any selected fault event happens, the Fault LED on the switch panel will light up and the electric relay will signal at the
same time.
Figure 5-103. Port Link Down/Broken and Fault Alarm screens.
5.9.2 System Warning
SYSLOG Setting
The SYSLOG is a protocol that transmits event notifications across networks. For more details, please refer to RFC 3164 - The BSD
SYSLOG Protocol.
Figure 5-104. System Log Configuration screen.
Table 5-83. System Log Configuration screen options.
Label Description
Server Mode Indicates existing server mode. When the mode operation is enabled, the syslog message will be sent to sys-
log server. The syslog protocol is based on UDP communications and received on UDP port 514 and the sys-
log server will not send acknowledgments back to the sender since UDP is a connectionless protocol and it
does not provide acknowledgments. The syslog packet will always be sent even if the syslog server does not
exist. Possible modes are:
Enabled: enable server mode
Disabled: disable server mode
SYSLOG Server IP
Address Indicates the IPv4 host address of syslog server. If the switch provides DNS functions, it also can be a host
name.