G.703/G.704 NTU W/V35
14
3. Installation
Once the MT335A is properly configured, it is ready to connect to the
G.703/G.704 interface, to the serial port, and to the power source. This section
describes how to make these connections.
3.4 Connecting to the G.703 Network
The MT335A is equipped with a single RJ-48C jack for connections to a 120
ohm twisted pair G.703/G.704 network interface (see Figure 3).
Figure 3.
Rear Panel, Showing Location of Connectors.
If your G.703/G.704 network terminates via RJ-48C, use the connection diagram
(Figure 4) following the pinout and signals chart below to connect the 120 ohm
G.703/G.704 network channel.
3.4.27 O
PENING
THE
C
ASE
Open the case by inserting a screwdriver into the slots and twist the screwdriver
head slightly. The top half of the case will separate from the lower half of the
case. Take caution not to damage any of the PC board mounted components.
Made in the USA
Interface
Power
Line
Power
V.35 Interface
Line
