12
1.877.877.2269
BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
CHAPTER 5: ADDRESSING
5.2.2 SETTING UP IR RECEIVER ADDRESS
The address of the receiver can be set up by the Address Switch.
Keypad button addressing switch
IR receiver addressing switch
FIGURE 5-5. IR RECEIVER ADDRESSING SWITCH
1. Push the IR receiver addressing switch on the rear side of the keypad using a small screwdriver or wire; backlight LEDs switch off
to indicate Set Address Mode.
2. Button LEDs indicate an ADDRESS in binary code—Button 1 bit 0, Button 2 bit 1 etc… Push buttons to toggle address bits to the
requested value of the ADDRESS (this is the same as in addressing keypad buttons, see above).
3. Push the keypad button addressing switch to save an ADDRESS to non-volatile memory and to enter keyboard Standard Mode—
backlight LEDs are switched on to indicate Standard Mode.
