877-877-2269 | blackbox.com
Page 18
Chapter 4: Operation
4.3.1 Capturing IR Codes
All controllers are equipped with an IR capture sensor and are able to capture IR codes. Captured IR codes can be used in both
controller models.
The capture procedure consists of the following steps:
1. Connect the capture unit and the PC with ControlBridge Builder to the same Network.
2. Arrange the IR remote and the capture unit as described below.
IR remoter
1
2
1
2
3
4
1
2
1
2
3
4
SERIAL
IR/SERIAL
GENERAL I/O
RELAY
IR SENSOR
PWR LINK CPU
Figure 4-1. IR remote configuration.
• Be sure to set the proper distance between the capturing unit and the remote unit to accommdate the the capturing unit’s
requirements.
• Start ControlBridge Builder and go to the appropriate driver and command
• Set the IP address of the unit used for capture.
• Push the Start Capture button in ControlBridge Builder and then press the appropriate button on the IR remote.
Button Start Capture
Figure 4-2. Start Capture button.