9
1.877.877.2269
BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
3.1.1 VIDEO LINK
Each Agility Zero U Transmitter is supplied with either a DVI-D (single link) or a DisplayPort™ video connector. Video signals at
pixel clocks up to 165MHz (equivalent to a maximum resolution of 1920 x 1200 at 60Hz) are permissible.
TO MAKE A VIDEO LINK
Connect the Agility Zero U Transmitter video connector to the DVI-D or DisplayPort™ socket of the host computer:
Agility Zero U Transmitter DVI-D model
Host computer
DVI-D video
port
Agility Zero U Transmitter DP model
Host computer
DisplayPort
connector
3.1.2 NETWORK LINK
Agility local and remote units can either be connected directly to each other or via a high speed network.
A single Gigabit Ethernet port is located on the front panel. For direct links via Ethernet cable, the length of cable should not
exceed 100 metres (328 feet). Network cables used for connections may be category 5, 5e, 6 or 7 twisted-pair cable. The
Agility Zero U Transmitter has an autosensing capability on its network interfaces, so for direct point-to-point connections, no
‘crossover’ Ethernet cable is required.
TO LINK THE AGILITY ZERO U TRANSMITTER
1 Connect a CAT 5, 5e, 6, or 7 cable to the Gigabit Ethernet socket on the front panel of the Agility Zero U Transmitter.
Please see
Appendix C
for important tips about networking Agility units.
CAT 5, 5e, 6, or 7 link
either directly from
the other Agility unit
or from a Gigabit
Ethernet switch
WW
W.B
LAC
KB
OX
.CO
M
WW
W.B
LAC
KB
OX
.CO
M
2 Connect the other end of the cable either directly to an Agility remote unit or to a Gigabit Ethernet switch, as appropriate.
3 [For connections via a network] repeat steps 1 and 2 for the other Agility unit(s).